![]() Finally, we make enp0s3 the primary slave. Next, we provide the bonding device name in the Network section. I am a little sceptical about this Npcap Loopback Adapter thing and it seems it only appeared after the latest Windows 10 upgrade. where it came from (which software) and 3. Subsequently, the Network section says that we use DHCP.įurther, let’s move to the enslaved connections enp0s3 and enp0s8: $ cat workĪs before, the Match section says which interface this file refers to. The Npcap Loopback Adapter - Microsoft Community Skip to main content 2. Let’s notice that the Name field in the Match section indicates that this configuration applies to the bonding device. Now let’s examine the bond connection: $ cat work Next, we add the device’s details in the Bond section. So in the NetDev section, we define the type and name of the device. Now, let’s review the setup: $ ls -1 /etc/systemd/networkįirst, let’s look into the bond device: $ cat dev So per convention, we should start their names with numbers. Let’s notice that the files are parsed in alphabetic order. In addition, the Permanent HW addr contains the MAC address of each slave interface before bonding. We can find that the currently used slave link is enp0s3. Primary Slave: enp0s3 (primary_reselect always) Now let’s check the bonding configuration in the /proc/net/bonding/nm-bond file: $ cat /proc/net/bonding/nm-bondĮthernet Channel Bonding Driver: v5.15.0-47-genericīonding Mode: fault-tolerance (active-backup) Moreover, let’s notice that the MAC address of all three interfaces is the same. So we can find out that the bonding is working with two slaves. Link/ether 6a:23:45:28:ac:0f brd ff:ff:ff:ff:ff:ff permaddr 08:00:27:fa:13:16Ĥ: nm-bond: mtu 1500 qdisc noqueue state UP mode DEFAULT group default qlen 1000 After the ncap disable try disable then enable wifi adapter to see if you get a selection of wifi networks. It shows you are connected by Ethernet but not connected by wifi. Link/ether 6a:23:45:28:ac:0f brd ff:ff:ff:ff:ff:ff permaddr 08:00:27:42:6c:e3ģ: enp0s8: mtu 1500 qdisc fq_codel master nm-bond state UP mode DEFAULT group default qlen 1000 Re: 'Npcap Loopback Adapter doesnt have a valid IP configuration' Wireless Out. ![]() Let’s reboot the system and check the links: $ ip linkġ: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |